SIP User's Manual
6
.
Configuring
the MediaPack
Version 2.4
159
June 2008
Table
6-18: PPPoE Settings Parameters
Parameter
Description
3.
Use the commands in [] to change the parameters.
6.3.1.3 Static Routes
The
Static Routes
option allows you to add static IP routing rules. Before sending an IP
packet, the gateway searches this table for an entry that matches the requested destination
host / network. If such an entry is located, the gateway sends the packet to the indicated
router. Up to 50 routing entries are available.
The first default route will also be shown on the Quick Setup page. To enter a default route,
use the following values:
Dest. IP: 0.0.0.0
Dest Mask: 0.0.0.0
GW IP: IP address of the default gateway
Metric: 14
¾
To add static routes:
1.
Open the ‘Static Routing Table' screen (
Advanced Configuration
menu >
Network
Settings
>
Static Routes
option).
Figure
6-21: Static Routing Table Screen
2.
Configure the static routes (refer to
995H1057H
Table
6-19
).
3.
Click the
Insert
button to add the static rules.
4.
To save the changes to the flash memory, refer to Section
1058H
6.9
,
’
1059H
Saving Configuration
Settings on the MediaPack
’ on page
1060H
131
).
To remove a static route entry, select the radio button corresponding to the static route
entry, and then click
Remove
. To view dynamic IP routes (i.e., Dynamic Routing Table),
click
View Dynamic Routes
.
Table
6-19: Static Routing Table Parameter Description
Column Name
Description
Destination IP Address
Specifies the IP address of the destination host / network.
