MP-40x SIP MediaPack BRI Series
SIP User's Manual
44
Document #: LTRT-53301
6.
To use the B-Channel based routing feature, configure the “Add NPI as Prefix to
Calling Number” parameter to ‘Enable’. In this mode the B-Channel number is used as
prefix for the source number.
7.
To use the Number Plan Indentifier (NPI) based routing feature, configure the “Add
NPI to calling number” parameter to ‘Enable’. In this mode the NPI number is used as
prefix for the source number.
8.
To use the Number Plan Indentifier (NPI) based routing feature, configure the “Add
NPI as Prefix to Called Number” parameter to ‘Enable’. In this mode the NPI number
is used as prefix for the destination number.
9.
To use the Type Of Number (TON) based routing feature, configure the “Add TON as
Prefix to Calling Number” parameter to ‘Enable’. In this mode the NPI number is used
as prefix for the source number.
10.
To use the Type Of Number (TON) based routing feature, configure the “Add TON as
Prefix to Called Number” parameter to ‘Enable’. In this mode the NPI number is used
as prefix for the destination number.
11.
Ignore progress indicator (PI): If enable the Gateway rejacts the PI that arrived from
the Network side and send Release immediately after the disconnect message.
12.
Routing & Manipulation: choose if Route first or Manipolate first.
13.
Play Ringback Tone to Tel: Determines the method used to play Ringback tone to the
Tel side
14.
Click the
Submit
button, and then repeat steps 3 through 5 for all the required ISDN
interfaces.
For additional information on configuring ISDN interfaces, refer to Section '
705H731H
ISDN Interface
Settings
' on page
706H732H
78
.
4.1.6
Configuring the SIP Parameters
The SIP parameters are configured using the options of the
SIP Gateway
submenu
(
Protocol Management
menu >
SIP Gateway
submenu).
SIP configuration includes the following main sections:
General SIP parameters
Proxy and Registration parameters
SIP users
When no Proxy is implemented, the internal Tel to IP Routing table is used to route the
calls (refer to Section '
707H733H
Tel to IP Routing Table
' on page
708H734H
90
). In our example setup, Unit A
and Unit B can either connect using the Proxy Server or Internal Routing tables. The
procedure below describes both methods.
¾
To configure the SIP parameters take the next 7 steps:
1.
Access the 'SIP General Settings' screen (
Protocol Management
menu >
SIP
Gateway
submenu >
SIP
General Settings
option).
