MP-40x SIP MediaPack BRI Series
SIP User's Manual
102
Document #: LTRT-53301
3.
Click the
Submit
button to save your changes.
4.
To save the changes to the flash memory, refer to Section
1050H
6.9
,
’
1051H
Saving Configuration
Settings on the MediaPack
’ on page
1052H
131
).
Table
6-17: WAN and LAN IP Settings Parameters
Parameter
Description
LAN Interface Parameters
Interface Mode
[ipmode static]
Defines how the IP address of the interface is configured. For the LAN
interface, you must assign a static IP address.
IP Address
[ipaddress <addr> <mask>]
Defines the interfaced IP address and subnet mask. This is only valid if the
interface mode is set to static.
Default LAN IP address: 192.168.1.1 (subnet mask: 255.255.255.0)
Subnet Mask
Defines the network mask of the IP address specified above.
MTU
[mtu <value>]
Defines the Maximum Transfer unit (MTU) of this IP interface. This value
specifies the size of the largest packet that can be sent over this interface in
one piece.
The default is 1,500.
[medium [10 full |10 half | 100
full | 100 half | auto]
Note:
In the current version,
Media settings can only be
configured using CLI.
Defines the interface mode.
Valid options include:
Auto = enables auto negotiation
10T = interface configured for 10 Mbps Half duplex
10TX = interface configured for 10 Mbps Full duplex
100T = interface configured for 100 Mbps Half duplex
100Tx = interface configured for 100 Mbps Full duplex
WAN Interface Parameters
Interface Mode
[ipmode]
Valid options include:
DHCP (default)
PPPoE
Static
IP Address
[ipaddress <addr> <mask>]
Defines the interfaced IP address and subnet mask. This is only valid if the
interface mode is set to static.
Default WAN IP address: 192.168.2.1 (subnet mask: 255.255.255.0)
Subnet Mask
Define the network mask of the IP address specified above.
Note:
This parameter is only valid if the interface mode is set to Static.
ACL IN
[[no]acl-in]
Enables or disables the Access Control List for inbound traffic.
Valid options include:
Enable
Disable (default)
Note:
In the current version, ACL can only be configured using CLI.
ACL OUT
[[no]acl-out]
Enables or disables the Access Control List for outbound traffic.
Valid options include:
Enable
Disable (default)
Note:
In the current version, ACL can only be configured using CLI.
MTU
[mtu <value>]
Defines the Maximum Transfer Unit (MTU) of this IP interface. This value
specifies the size of the largest packet that can be sent over this interface in
one piece.
The default is 1,500.
If PPPoE is used, the actual MTU is reduced to the MTU determined during link
negotiation. In most cases, this is 1,492.
