SIP User's Manual
6
.
Configuring
the MediaPack
Version 2.4
159
June 2008
Table
6-17: WAN and LAN IP Settings Parameters
Parameter
Description
[medium [10 full |10 half | 100
full | 100 half | auto]
Note:
In the current version,
Media settings can only be
configured using CLI.
Defines the interface working mode.
Valid options include:
Auto = enables auto negotiation
10T = interface configured for 10 Mbps Half duplex
10TX = interface configured for 10 Mbps Full duplex
100T = interface configured for 100 Mbps Half duplex
100Tx = interface configured for 100 Mbps Full duplex
Using CLI
To change the Tel -> IP interfaces parameters:
1.
Log on to the system.
2.
From the main configuration mode, change to the “ip_interface” mode.
3.
To enter the “ip_interface” mode use the command:
ip_interface
<LAN | WAN>
4.
Use the commands in square brackets ([]) to change the parameters.
Note:
The media configuration is configured in the “port ethernet” mode. To enter the “port ethernet” mode, use
the command “port ethernet 0 <port num>”. Use port number “0” for the LAN interface and port number "1" for
the WAN interface.
6.3.1.2 PPPoE
The
PPPoE
option enables you to configure the Point-to-Point Protocol over Ethernet
(PPPoE) settings.
¾
To configure the PPPoE parameters:
1.
Open the ‘PPPoE' screen (
Advanced Configuration
menu >
Network Settings
>
PPPoE
option).
Figure
6-20: PPPoE Screen
2.
Configure the PPPoE settings according to
992H1053H
Table
6-18
.
3.
Click the
Submit
button to save your changes.
