MP-40x SIP MediaPack BRI Series
SIP User's Manual
46
Document #: LTRT-53301
4.
In the 'SIP Proxy & Registration' screen, perform the following:
a.
When working with a Proxy server, set the ‘Enable Proxy’ field to ‘Enable', and
then in the ‘Primary Proxy' field, enter the IP address of the primary Proxy server.
When no Proxy is used, the Internal Routing table is used to route the calls (refer
to sections '
709H735H
Tel to IP Routing Table
' on page
710H736H
90
and '
711H737H
IP to Tel Routing Table
' on
page
712H738H
91
).
(In our example setup for
Unit A
, 'Enable Proxy' is set to ‘Enable’ and 'Primary
Proxy' is defined as 10.33.2.20.)
b.
In the ‘SIP Domain Name’ field, enter the SIP domain name. (In our example
setup for unit A, the SIP domain name is defined as 10.33.2.35).
c.
From the ‘Enable Registration’ drop-down list, select one of the following for
proxy registration:
♦
'Disable': the MediaPack doesn't register to a Proxy server/Registrar
(default).
♦
‘Enable’: the MediaPack registers to a Proxy server/Registrar at power up
and every ‘Registration Expiry Time’ seconds; The MediaPack sends a
REGISTER request according to the ‘Authentication Mode’ parameter.
(In our example setup for
Unit A
, 'Enable Registration' is set to ‘Enable’.)
d.
From the 'Authentication Mode' drop-down list, select one of the following:
♦
’Per User’ (default): requires the configuration of the SIP users as described
in Step 4.
♦
‘Per Gateway’: requires that you provide ‘Default user name’, ‘Default user
password’ and ‘Default user cnonce’
(In our example setup for
Unit A
, the Authentication mode is set to ’Per User’.)
e.
Click the
Submit
button.
5.
If in the 'SIP Proxy & Registration' screen the Authentication mode was set to ‘per
user’, perform the following:
a.
Access the 'SIP Users' screen (
Protocol Management
menu >
SIP Gateway
submenu >
SIP Users
option).
