SIP User's Manual
3
.
Installing
the MediaPack
Version 2.4
21
June 2008
3
Installing the MediaPack
This section provides information on the installation procedure for the MediaPack.
Caution Electrical Shock
The equipment must only be installed or serviced by qualified service personnel.
¾
To install the MediaPack:
Unpack the MediaPack (refer to '
607H627H
Unpacking'
below).
Check the package contents (refer to '
608H628H
Package Contents'
below).
Mount the MediaPack (refer to '
609H629H
Mounting the MediaPack'
on page
610H630H
22
).
Cable the MediaPack (refer to '
611H631H
Cabling the MediaPack'
on page
612H632H
24
).
After connecting the MediaPack
to the power source, the
Ready
LED on the front panel
turns to green (after a self-testing period of about one minute). Any malfunction changes
the
Ready
LED to red.
When you have completed the above relevant sections you are then ready to start
configuring the gateway (Chapter
613H633H
5
on page
614H634H
52
).
3.1
Unpacking
¾
To unpack the MediaPack take the next 6 steps:
1.
Open the carton and remove packing materials.
2.
Remove the MediaPack gateway from the carton.
3.
Check that there is no equipment damage.
4.
Check, retain and process any documents.
5.
Notify AudioCodes or your local supplier of any damage or discrepancies.
6.
Retain any diskettes or CDs.
3.2
Package Contents
Ensure that in addition to the MediaPack, the
package contains:
External power supply with AC power cable
Three brackets (two short, one long) and bracket-to-device screws for 19-inch rack
installation
CD with software and documentation
Printed copy of MediaPack Fast Track Installation Guide
