MP-40x SIP MediaPack BRI Series
SIP User's Manual
108
Document #: LTRT-53301
¾
To configure QoS:
1.
Open the ‘QoS Profiles' screen (
Advanced Configuration
menu >
Network Settings
>
QoS Source Classes
option).
Figure
6-23: QoS Source Classes Screen
2.
In the Rate Limit Setting of the WAN Interface group, define the rate limit of the WAN
link in the 'Rate Limit' field.
3.
Select a traffic class (e.g., local-default) that you want to configure, by selecting the
radio button corresponding to the class.
4.
Configure the QoS profile according to
998H1061H
Table
6-21
.
5.
Click the
Modify
button.
6.
To save the changes to the flash memory, refer to Section
1062H
6.9
,
’
1063H
Saving Configuration
Settings on the MediaPack
’ on page
1064H
131
).
Table
6-21: QoS Parameters Description
Parameter
Description
Rate Limit
[rate-limit <num>]
Specifies the available upstream bandwidth. This parameter is required for the
scheduler to operate correctly.
For each of the four available traffic Classes, specify the following parameters:
Name
Specifies the name of the service class to be configured.
There are 3 built in service classes
Local-voice: Locally generated RTP packets
Local-default: All other locally generated traffic
Default: Routed packets
A fourth class “user-defined” is provided.
The Access control list can be used to override local provided defaults (listed
above or to assign the “user-defined” source class
For more information see: access control list
In the CLI the name is used to enter the configuration mode for the specified
profdile.
