ATS Maximus MCJ2000 Series, Reference Manual

Page: 122 / 214

4-6 Maximus Reference Manual MANU-MAXIMUS-02
Revision-02
Initial Setup Chapter 4: Color Terminals
Initial Setup
The Initial Setup Menu, shown in Figure 4-3 on page 4-5 , enables you to configure the basic
parameters to quickly connect your Maximus to its host/network and to access other menus.
Simultaneously press and hold down the
clear and enter keys for about five seconds (and
enter the password if prompted for it) to launch the Initial Setup menu.
Initial Setup Menu Parameters
The following sections describe the Initial Setup Menu parameters (the Initial Setup Menu
screen is shown in
Figure 4-3 on page 4-5 ).
Host IP Address
This sets the IP address of the computer with which the terminal communicates. Press the
“F1” key to select the
Host IP Address parameter. The screen prompts you to enter an IP
address for the host as shown in Figure 4-4 .
Figure 4-4 Host IP Address Prompt (Initial Setup)
Maximus terminals leave the factory without a password to enter the configuration menus.
You can set a password via the Setup menu as described in
"Set Password" on page 4-17 .
NOTE:
03:38:15
Friday
Nov 7, 2014
Enter the Host
TCP/IP Address:
_ _ _ . _ _ _ . _ _ _ . _ _ _
The IP selections display when host type is serial mode as well as when host type is Ethernet.
If host type is serial, these settings are ignored. For more information, see
"Host Type" on
page 4-15 .
NOTE: