ATS Maximus MCJ2000 Series, Reference Manual

Page: 42 / 214

2-10 Maximus Reference Manual MANU-MAXIMUS-02
Revision-02
Terminal Installation Chapter 2: Installation
6. If you separated the terminal from the mounting base, reinstall the terminal on
the base by reinstalling the terminal’s hinge screws or by sliding the fixed hinge
pin into its mating top hole, lifting the lower spring-loaded pin, and pivoting the
terminal until the pin drops into its mating hole. (
"Terminal Wiring Access" on
page 2-5 ).
7. If you unplugged any cables between the terminal and base, reconnect them as
they were originally.
Main Components
This section provides the locations of the main components inside the Maximus terminal.
Figure 2-8 shows the main components and modules locations with a Power over Ethernet
module installed.
Figure 2-8 Maximus Component Locations (1)
Figure 2-9 shows the main components and modules with a WiFi module and an Accu-Touch
Biometric reader installed (the PoE and WiFi module use the same location in the terminal.
Power over Ethernet modules are typically not installed with a GSM or Serial module
installed.
Figure 2-8 and Figure 2-9 illustrate locations only and does not represent
functionality or available configurations.
NOTE:
Battery Charger Board
Main Board
Option Module
(e.g., GSM, Serial)
DIDO Module
Biometric
Reader Area
PoE Module
Card Swipe
Reader
UPS Battery