3-22
Maximus Reference Manual
MANU-MAXIMUS-02
Revision-02
ATS Setup Mode
Chapter 3: Monochrome Terminals
9.
Next the terminal displays the default/saved addressing mode for the terminal.
The default value is
Dynamic DHCP
. In DHCP mode the terminal receives its IP
address from the connected DHCP server (therefore the terminal IP address may
periodically change). The terminal uses standard DHCP conventions, does
automatic lease renewal, and uses only standard option codes in the range 0
through 127.
Press the
enter
key to accept DHCP mode and continue or press the
clear
key
to toggle the display between the
Static IP
and
Dynamic DHCP
selections.
If the terminal was already in the displayed mode (
Dynamic DHCP
or
Static IP
)
and you pressed the
enter
key without changing it, the terminal enters the
. Proceed to
•
The
Static IP
selection enables you to set the terminal to a permanent IP
address. The static IP address does not change until you type another one
into the terminal.
•
When the terminal displays the desired selection (
Dynamic DHCP
or
Static
IP
) press the
enter
key to save the selection and continue to the next
parameter.
•
If you changed to the
Static IP
selection the terminal displays the next set
of parameters that enable you to define the static IP addressing parameters
starting with the
Setup Clock IP
parameter.
•
If the terminal is set to
Static IP
(and rebooted) the terminal displays S
tatic
IP
for the
Type
.
You can access the following parameters by pressing the
clear
key, toggling
the
Static IP
and
Dynamic DHCP
selections and re-saving
Static IP
.
Setup Addressing
Type: Dynamic DHCP
ATS supports Internet Protocol version 4 (IPv4) addressing. If you type an invalid IP, subnet
mask, or other value, the terminal tells you the error and prompts you to retry using a valid
entry.
NOTE:
