ATS Maximus MCJ2000 Series, Reference Manual

Page: 40 / 214

2-8 Maximus Reference Manual MANU-MAXIMUS-02
Revision-02
Terminal Installation Chapter 2: Installation
Figure 2-5 Mounting Template Dimensions (Not to Scale)
2. Be sure all required wiring is present and any cable clamps properly installed.
Follow any applicable wiring codes.
3. Partially install the three upper screws.
4. Lower the mounting base onto the three upper screws then tighten them (refer
to
Figure 2-6 on page 2-9 or Figure 2-7 on page 2-9 depending on if you
separated the terminal or didn’t separate the terminal, respectively).
5. Install the bottom screw and tighten until snug.
6-5/8 in.
168.3 mm
0 in.
0 mm
-1/4 in.
-6.4 mm
4 in.
101.6 mm
2 in.
50.8 mm
0 in.
0 mm
1-9/16 in.
40.2 mm
Mount 39 inches (99 cm) from the bottom of the Maximus base to the floor (recommended for ADA requirement)