3-50
Maximus Reference Manual
MANU-MAXIMUS-02
Revision-02
Test Mode
Chapter 3: Monochrome Terminals
3.
Press the
enter
key. The terminal displays the
in progress
message. Hold a
smart card up to the terminal near the smart card reader (just under the
keypad).
4.
The terminal displays if the test passed or failed. When finished, press the clear
key to return to the
Smart Card Test
option. You can now press the enter key
to restart the test or press the clear key to exit the test and proceed to the next
menu item (
Serial Test: Direct
).
Serial Test: Direct
This test requires specific loopback “jumper” and is typically only performed by an ATS service
technician. It is noted here for reference purposes.
1.
Install the “jumper” in the serial port on the terminal.
2.
In the
Test Mode
menu, press the
clear
key until the
Serial Test: Direct
option
appears.
3.
Press the
enter
key to start the test. The terminal reports that the test is in
progress. When the test is complete the terminal displays the result.
4.
When you are finished, press the
clear
key to exit the direct serial test and
display the
Serial Test: Printer
prompt. You may now remove the jumper from
the terminal.
in progress
Smart Card Test
Test Mode
Serial Test: Direct
Test in progress
Serial Test: Direct
