2-6
Maximus Reference Manual
MANU-MAXIMUS-02
Revision-02
Terminal Installation
Chapter 2: Installation
Terminal Installation
This section describes how to wall mount the Maximus terminal and provides the locations of
the main components inside.
Opening and Separating the Case
While not necessary, you may find it easier to install the mounting base on the wall if you
separate the base from the terminal. Use the following procedure if you wish to separate the
mounting base from the terminal:
1.
Unlock the terminal with the supplied key (see
for the chassis lock
location).
2.
Open the unit by pulling gently on the right-hand edge of the terminal, so it
swings open on the hinges (the terminal is hinged to the base on the left edge
as you face it).
3.
If there are any short jumper cables between the terminal and the base, unplug
each jumper from the terminal, making a note of where each one goes so you
can reconnect them.
4.
The terminal uses a fixed upper hinge-pin and a spring-loaded lower hinge-pin.
Raise the spring-loaded lower pin until the terminal can pivot sideways enough
to clear the lower pin support (see
5.
Then, slide the terminal upward to free the upper pin. When the terminal and
base are separated, lay the terminal aside in a safe place.
Figure 2-3
Chassis Key Location
Chassis Lock & Key
