Installation
22
AT&T SB67010 Gateway, SB67030 Deskset System Administrator’s Guide
Gateway Installation
The system requires at least one SB67010 PSTN Gateway for receiving or making external calls. You can place the Gateway on
a table top or mount it into a standard 19” metal rack. The Gateway must be installed within three feet of the building ground
point. Install each Gateway using the following instructions.
To mount the Gateway into a standard 19” rack:
Figure 19. Rack-mount Bracket
1. Remove the two Gateway mounting brackets and six screws from the packing
tissue.
2. Position the right bracket at the front of the chassis, as shown in Figure 19.
3. To align the screw holes, place the
bracket on the chassis so that the
locating indent on the bracket matches
the indent on the chassis.
4. Insert each of the three screws into the
holes illustrated in Figure 20 and
tighten securely. Repeat the process
for the left bracket.
5. Position the Gateway into the 19”
metal rack, as shown in Figure 21.
6. Insert a top mounting screw (not
included) in one side and turn it several turns to establish support. Repeat for
the other side.
7. Tighten the screws.
Figure 21. Rack Installation
Mounting Bracket
Mounting
Screws
Locating Indent
Figure 20. Bracket Installed
