AT&T 6386 WGS, Installation And Maintenance Manual

Page: 79 / 213

If you are upgrading AUDIX Voice Power from a previous release,
see Chapter 5, Upgrade Procedures before proceeding. The upgrade
procedure will refer you to the necessary sections in this chapter.
If you are adding AUDIX Voice Power to an existing system, or if you
are reinstalling application software after an unrecoverable failure, the
UNIX operating system must be reinstalled before you can install or
reinstall AUDIX Voice Power. Begin with the instructions below for
Verifying Hard Disk Size.
Verifying Hard Disk Size
Before beginning the software installation, the size of the hard disk should
be verified. To determine the hard disk size, follow these steps:
1
2
3
4
5
Insert the Customer Test disk supplied with the system into drive A.
Boot the system by turning power ON or by pressing the [Reset] button if
the system is already on.
The system boots from the Customer Test disk and displays the
Customer Test introduction screen.
Press [Enter] to continue.
The Customer Test main menu appears.
Use the down arrow key to move the highlight to Setup Utility and
press [Enter].
Setup displays the current settings for the system on a scrollable menu
(6386SX, 6386/25 and 6386E/33) or on two pages (6386, 6386E).
The information displayed will indicate the hard disk type or the
hard disk size. Locate the disk in the following table and record the size
and number of cylinders for use later in allocating filesystems.
Type Cylinders Size
12 1024 68 MB
25 1021 135 MB
31 814 304 MB
32
977 81 MB
Software Installation 3-3