AT&T 6386 WGS, Installation And Maintenance Manual

Page: 53 / 213

VDC600 Board Configuration and Installation
The VDC600 is the AT&T equivalent of a Video Graphics Array (VGA)
board.
Note
The 6386SX WGS has a video controller built into the motherboard.
The VDC600 should not be used with the 6386SX WGS.
The default settings are used for the DIP switch and jumpers on the Video
Display Controller. The locations and settings are shown in Figure 2-30.
For more information on default settings, see the Video Display Controller
Installation Guide packed with the board.
The VDC should be installed in the leftmost expansion slot on desktop
configurations or in the rearmost expansion slot on floor models. Follow the
general instructions for installing expansion boards described in the section
General Installation Instructions, in this chapter.
N o t e
The VDC600 must be installed in a 16 bit expansion slot.
Hardware Installation
2-39