AT&T 6386 WGS, Installation And Maintenance Manual

Page: 28 / 213

2 Holding the expansion board by its edges, insert the board into the
correct slot as shown in Figure 2-9.
Be sure that the bracket on the expansion board is at the back of the
chassis (top of the chassis for floor models) and fits into the space left by
the slot cover. Be sure that the connector edge of the board is properly
aligned with the socket on the adapter board. The front edge of long
cards goes in the alignment guide attached near the front (bottom on
floor models) of the computer enclosure.
FIGURE 2-9 Inserting a Circuit Board into an Expansion Slot
3 When the expansion board is properly seated in the expansion slot, press
down evenly on the edges of the board to ensure a solid connection.
2-14 Hardware Installation and Maintenance