AT&T 6386 WGS, Installation And Maintenance Manual

Page: 81 / 213

5
Type y and press [Enter].
The system prompts you to partition the hard disk with the following messages
messages:
C y l i n d e r s
Partition Status Type Start End Length %
THERE ARE NO PARTITIONS CURRENTLY DEFINED
SELECT ONE OF THE FOLLOWING:
1. Create a partition
2. Change Active (Boot from) partition
3. Delete a partition
4. Exit (Update disk configuration and exit)
5. Cancel (Exit
without updating disk configuration)
Enter Selection: 1
The default, 1, for Create a partition is pre-entered on the screen.
In some situations, you may see a partition definition as shown below.
N o t e
Cylinders
Partition Status Type Start End Length
%
1
Active
UNIX O <end> <max>
100
In this case, it will be necessary for any existing partitions to be deleted
and then recreated for the system to work properly. To delete any
existing partitions, follow these steps:
a Type 3 for Delete a Partition and press [Enter].
The system prompts you to enter the number of the partition
to delete.
b Type the first partition number listed and press [Enter].
Repeat these two steps until all existing partitions have been deleted.
After all partitions have been deleted, continue with step 6.
Software Installation 3-5