AT&T 6386 WGS, Installation And Maintenance Manual

Page: 113 / 213

Upgrade Procedures
As new releases of AUDIX Voice Power become available, it is desirable to
update the customer system to make the latest features available, and to
simplify maintenance and troubleshooting.
For a System 25 with IS-II, the IS-II procedures should be used. See
Updating ISII and Applications in Chapter 7 of the AT&T Integrated Solution
II Installation and Maintenance Manual.
For a System 25 without IS-II, or for a System 75, the procedures are
discussed in this Chapter. You will need the AUDIX Voice Power Upgrade
Utility R1.0.
Upgrade from Release 1.1 to Release 2.0
The procedure for upgrading from AUDIX Voice Power Release 1.1 to
Release 2.0 is outlined below. The exact procedure for each step is included
in the step or described elsewhere, either in this chapter, or in other parts of
this document. Note that you must reinstall the UNIX system as part of this
procedure.
1 Log in to the system as root.
2 Insert the AUDIX Voice Power Upgrade Utility diskette into the disk
drive.
3 At the # prompt, type installpkg and press [Enter].
4 When prompted, press [Enter] again.
5 Follow the instructions on the screen to complete these steps
•
The voice system will be stopped automatically (if running) so that no
more calls are accepted.
•
Remove the AUDIX Voice Power Upgrade Utility diskette from the
disk drive.
Upgrade Procedures 5-1