Associated Research OMNIA II 8204, Operation And Service Manual

Page: 47 / 264

41
DUT-HV Setup (82x6 and 82x7)
The DUT-HV selection activates an additional parameter in the AC Withstand, DC
Withstand
and IR Tests parameter screens. The additional parameter is called “DUT
Output
” and its function is to control the high voltage relay at the DUT output.
When the DUT Output parameter is turned ON during an AC Withstand, DC
Withstand, or IR test, high voltage will be present at the DUT outputs as well as the
front and rear panel HV connectors. When the DUT Output parameter is turned OFF,
no high voltage will be present at the DUT connectors, only the front and rear panel
HV connectors will have high voltage.
From the Hardware Setting screen, you may turn the DUT-HV parameter selection ON
and OFF by pressing the “DUT-HV Setup” soft key. Selecting the DUT-HV = “OFF”,
will prevent the parameter from appearing on the AC Withstand, DC Withstand, and IR
test parameter setting screens. With DUT-HV = OFF, high voltage will automatically
be present on the DUT output.
Please refer to section
4.4. Test Parameters for additional parameter information and
screen appearance.
AC Source (82x7)
From the Hardware Setting screen, you may turn the AC Source parameter selection
ON and OFF by press the “AC Source” soft key. When the AC Source is turned ON,
the 500VA power source is available for use during RUN and LCT testing. An
additional set of parameters will be available in the RUN Test Parameter Setting
screen and the LCT Test Parameter Setting screen.
Please refer to section
4.4. Test Parameters for additional parameter information and
screen appearance.
Measurement
From the Hardware Setting screen, press
the “Measurement” soft key. As the soft key
is pressed, the measurement method will toggle between True RMS or Average.
4.2.5. Security
From the System Setup screen
press the “Security” soft key. The Security screen
appears as follows: