Arctic Cat 2014 XF 2-STROKE, Service Manual

Page: 86 / 196

83
FS230
3. Apply a small amount of grease to the oil seal lips.
4. Using a pair of snap ring pliers, install the snap ring
securing the oil seal in the crankcase.
CWI-098
5. Using the seal driver, carefully install the outer water
pump mechanical seal. Gently tap the seal down into
position until it seats itself against the crankcase.
FS232
6. Apply a light coat of grease to the sealing surface of
the pump driveshaft; then install Oil Seal Protector
Tool at the end of the shaft. Twist the shaft while
pushing it through the water pump seals until the
shaft gear engages with the drive gear of the crank-
shaft; then remove the tool.
CWI-101
7. Position the shim on the retainer end of the shaft;
then with the O-ring in place on the retainer, install
the retainer.
CWI-100
9. Place the impeller into position and secure with a cap
screw and washer. Be sure the rubber side of the
washer is directed towards the impeller. Apply blue
Loctite #243 to the threads of the cap screw and
tighten to 48 in.-lb.
CWI-096
11. Position the O-ring into the water pump cover; then
install the cover. Install the cap screws; then tighten
to 96 in.-lb using a crisscross pattern.