Arctic Cat 2014 XF 2-STROKE, Service Manual

Page: 129 / 196

126
XM141
5. Remove the spring and remaining spring seat.
PC112
CLEANING AND INSPECTING
1. Using parts-cleaning solvent, wash grease, drive belt
dust, and foreign matter off all components.
2. Inspect the rollers for damage, cracks, or wear.
3. Inspect the sheaves for any gouges, cracks, or other
damage. Also, inspect threaded areas of sheaves for
damaged or stripped threads.
4. Inspect the back-side cams and torque bracket for
cracks or damage. The ramp portions of the bracket
must be free of gouges and damage. Minor scratches
may be repaired using #320 grit wet-or-dry sandpaper.
5. Inspect spring for distortion, crystallization, or breaks.
6. Inspect the cover and movable sheave bearing for
wear. If wear is present, replace the bearing using
Movable Sheave Bearing Tool.
REPLACING TORQUE BRACKET
BEARING/COVER BEARING
1. Remove the snap ring.
2. Using a suitable driving tool, drive the bearing out.
3. Install the new bearing; then secure with a new snap
ring.
REPLACING ROLLERS
1. Bend the locking tabs down away from the shoulder
bolt; then remove the bolt.
XM143
2. Place a new roller into position and secure with the
shoulder bolt (with a drop of red Loctite #271).
Tighten securely and bend the lock tabs to contact
the bolt head.

NOTE: If the flat does not align with the tab, tighten
the shoulder bolt until it aligns.
XM144A
ASSEMBLING
1. Place the torque bracket onto the Driven Clutch
Compressor Tool; then install the spring seat (flat
side toward the spring) onto the torque bracket and
place the spring into position.
CAUTION
Do not use steel wool or a wire brush to clean driven
clutch components. A wire brush or steel wool will cause
the sheaves to be gouged (thus, the drive belt may not
slide properly between sheaves). Decreased performance
and possible accelerated drive belt wear will result.
! WARNING
Always wear safety glasses when using the bearing
driver.