66
FC040
4. Inspect the oil-injection pump drive gear for any
signs of worn or chipped teeth. If either condition
exists, replace the gear.
NOTE: Lubricate bearings thoroughly prior to
assembly.
REMOVING/INSTALLING OUTER
CRANKSHAFT BEARINGS
NOTE: The end bearings are not pressed onto the
crankshaft. The bearings can be removed simply by
sliding them off the crankshaft.
CM161
Inspect the crankshaft bearing area for wear. If any wear
is noted on either end, replace the crankshaft end.
NOTE: Install the bearings by sliding each bearing
onto the crankshaft making sure the retaining pin
hole (A) in the outer race of the bearing is properly
positioned and will align with the retaining pin (B) in
the crankcase.
IO019B
REED VALVE ASSEMBLY
1. Inspect the reed valves, stoppers, and valve blocks
for cracks or any deterioration.
XM227
2. Wash the reed valves, stopper, and cage assembly in
parts-cleaning solvent and blow dry.
3. Inspect the reed stopper height. Using a caliper, mea-
sure the distance from the seat to the bottom outer tip
edge of the stopper. Measurement must not exceed
specifications. If measurement is not within specifi-
cations, either bend or replace the reed stopper.
XM226
4. Inspect the reed-to-seat clearance. Using a feeler
gauge, measure the clearance. Clearance must be less
than 0.008 in. If clearance is not within specifica-
tions, replace the reed valve.
5. To assemble, place the reed valves on the cage with its
clipped corner positioned to the lower right hand corner
of the cage. Place the reed stopper assembly into posi-
tion and secure with the screws tightened to 8.5 in.-lb.
XM228A
Summary of Contents for 2014 XF 2-STROKE
