131
PC148A
NOTE: If the brake caliper was split, proceed to step
4. If not, proceed to step 6.
4. Install the brake disc and secure with the retaining
ring.
5. Making sure the seal is correctly installed in the
outer brake caliper, install on the inner caliper and
secure with two cap screws. Tighten to 25 ft-lb.
PC173A
6. Install the skid frame (see the Suspension section).
7. Install the brake shield and left-side footrest. Tighten
the cover cap screws to 8 ft-lb.
NOTE: Bleed the brake system if the brake caliper
was split in this section.
8. Install the driven shaft from the left-side making sure
the bearing remains at 90° to the shaft.
PC182
9. Secure the PTO-side engine mounting plate to the
crankcase with four cap screws (coated with blue
Loctite #243). Tighten to 30 ft-lb.
PC181
10. Install the drive clutch and tighten the clutch cap
screw to 51 ft-lb; then install the driven clutch and
drive belt. Tighten to 20 ft-lb and install the belt
guard.
11. Tighten the adapter sleeve onto the driven shaft bear-
ing with the ring nut. Tighten to 50 ft-lb; then bend a
tab on the locking washer into one of the slots in the
nut.
PC251A
NOTE: Make sure there is approximately 4.5 mm
gap between the retaining ring groove and the
adapter sleeve. This ensures the driven shaft is
installed correctly.
XM100A
NOTE: If no tabs align with the slots, tighten until
one aligns; then bend tab to lock nut.
Summary of Contents for 2014 XF 2-STROKE
