Arctic Cat 2014 XF 2-STROKE, Service Manual

Page: 33 / 196

30
EL-002A
8. Remove the cap screws securing the PTO-side front
spar to the steering support and shock mount bracket;
then remove the spar.

NOTE: Take care to not drop the spar inserts and
nuts when removing the spar.
9. Using a small needle-nose pliers, remove the servo-
motor cable holder; then pull the cable housings
down and out of the servomotor.
EL-004A
10. Slide each cable end out of the slot of the clutch; then
disconnect the harness from the servomotor.
11. Remove the cap screws and lock nuts securing the
shock mount bracket support to the shock mount
brackets; then remove the shock mount bracket sup-
port.
EL-003A
12. Remove idle speed control (ISC) hoses (A) from the
top of the throttle bodies; then disconnect the ISC
from the main harness (B). Remove the screws (C)
securing the ISC; then remove the ISC.
EL-006A
13. Loosen the four clamps securing the throttle body;
then lift up the throttle body and disconnect the cool-
ant hoses. Set the throttle body up and out of the way.
14. Remove the intake boot from the chassis.
15. Remove all three oil hoses from the front of the
engine.
EL-005A
16. Loosen the clamp securing the gasline hose to the
throttle body and remove the hose; then close-off the
hose and secure the hose up and out of the way.
17. Remove the main harness wrap and disconnect the
six harness connectors. Secure the harness up and
out of the way.
18. Remove the recoil starter from the engine. Secure it
out of the way.
19. Remove the cap screws securing the MAG-side
engine mount to the engine.
20. Remove the spark plug caps from the spark plugs;
then disconnect the knock sensor and coolant tem-
perature sensor connectors. Remove the cylinder
head vent hose.
! WARNING
The hose may be under pressure; remove it slowly to
release the pressure. Place an absorbent towel around
the connection to absorb gas.