Arctic Cat 2014 XF 2-STROKE, Service Manual

Page: 144 / 196

141
PC173A
8. Install new brake pads in the caliper and secure with
the retainer pin.
PC195
9. Bleed the brake system (see Bleeding Brake System
in this sub-section).
10. Install the brake shield and footrest; then install the
drive belt (see Drive Belt in this section) and driven
clutch. Tighten the driven clutch cap screw to 20 ft-
lb.
11. Adjust the track tension (see Track Tension in this
section) and track alignment (see Track Alignment in
this section).
12. Close and secure both side panels.
Brake Lever/Master
Cylinder Assembly
REMOVING
1. Slide a piece of flexible tubing over the ball of the
bleeder valve and direct the other end into a con-
tainer.
PC223A
2. Remove the two screws securing the reservoir cover
and remove the reservoir cover; then open the
bleeder valve. Allow the brake fluid to drain com-
pletely.
3. Place an absorbent towel around the connection to
absorb brake fluid. Remove the banjo-fitting bolt (A)
securing the brake fluid hose (B) to the master cylin-
der. Discard the two crush washers.
745-759A
4. Remove the pin (D) securing the brake lever to the
master cylinder.
5. Using a small screwdriver, compress the tabs of the brake-
light switch (E) to release it from the master cylinder.
6. Remove the two torx-head screws (F) and clamp
securing the brake reservoir to the handlebar; then
place a towel over the reservoir and remove the
assembly from the handlebar.
INSPECTING
1. Inspect the snap ring and pin securing the brake lever
for wear or damage; then inspect the brake lever for
cracks or damage.
2. Inspect the master cylinder reservoir and cover for
cracks and leakage.

NOTE: The master cylinder is a non-serviceable
component. If any wear or damage is detected, the
master cylinder must be replaced.
CAUTION
Brake fluid is highly corrosive. Do not spill brake fluid
on any surface of the snowmobile.