113
XM044A
2. Secure the MAG-side of the starter motor to the
retaining plate using the eight cap screws (threads
coated with blue Loctite #243). The washer and neg-
ative battery cable must be installed in the upper
location. Tighten to 96 in.-lb.
XM043A
3. Install inner snap ring onto the starter motor (if
removed during removing); then install the gear and
secure using outer snap ring making sure both snap
rings are fully seated.
XM041A
4. Secure the positive battery cable to the starter motor
and tighten to 72 in.-lb; then install the red cap over
the terminal.
XM040A
5. Install the drive clutch and tighten to 51 ft-lb; then
install the belt and driven clutch.
6. Install the throttle body boot; then install the throttle
bodies making sure to connect the PTO-side coolant
hose, oil pump rod, and injection connections.
7. Secure the throttle bodies using four existing clamps.
8. Install the shock mount support bracket to the chassis
using existing cap screws. Tighten to 20 ft-lb.
XM038A
9. Secure the ECM and front facia assembly to the
chassis using the existing self-tapping screws.
Tighten securely.
10. Install the resonator and expansion chamber and
secure using existing springs.
11. Install the hood, left-, and right-side access panels.
12. Connect both battery cables to the battery making
sure both are secure; then install the seat.
INSTALLING (6000)
1. Secure the starter motor using the existing four cap
screws (B) (threads coated with blue Loctite #243).
Tighten to 25 ft-lb.
Summary of Contents for 2014 XF 2-STROKE
