Arctic Cat 2014 XF 2-STROKE, Service Manual

Page: 136 / 196

133
MS357A
2. Using a suitable press positioned against the tension-col-
lar of the drive sprocket (located on the gear case) and of
the driveshaft, press the drive sprockets off the driveshaft.
ZJ217
ZJ218A
CLEANING AND INSPECTING
1. Thoroughly wash all metallic components in parts-
cleaning solvent. Dry using compressed air.
2. Wash all non-metallic components with soap and water.
3. Inspect the driveshaft for damaged splines or
stripped threads.
4. Inspect the seals for any breaks or damage.
5. Inspect the track for cuts, gouges, or wear.
6. Inspect the brake disc for wear or cracks.
7. Inspect the track drive sprockets for wear or damage.
INSTALLING

NOTE: The drive sprockets must be installed on the
brake side.
ZJ216A

NOTE: Prior to installing the sprockets onto the
driveshaft, lightly chamfer the inside edge of the
sprocket to avoid binding.
MS362
1. Properly align the scribed line on the driveshaft
(from removing) with the timing arrow on the drive
sprocket; then slide the sprocket onto the driveshaft
as far as it will go.
MS360A
2. Using a suitable press and fixture, press the drive-
shaft into the sprocket until it aligns with the line
scribed in removing.
CAUTION
Always press against the tension-collar of the drive
sprockets or damage to the components will occur.