Arctic Cat 2014 XF 2-STROKE, Service Manual

Page: 61 / 196

58
33. Route the stator harness through the opening in the
crankcase; then secure the stator to the stator plate
with the screws (coated with blue Loctite #243).
Tighten to 10 ft-lb.
34. Secure the upper ignition timing sensor with cap
screws (coated with blue Loctite #243). Tighten to
53 in.-lb; then install the wiring grommet into the
notch of the crankcase.
35. Secure the lower ignition timing sensor and bracket
with two screws (coated with blue Loctite #243).
Tighten to 53 in.-lb; then install the grommet. With
the stator harness properly positioned, install the
plate and cap screw (coated with blue Loctite #243).
Tighten to 53 in.-lb.
CWI-074
36. Install the key in the crankshaft (if removed).

NOTE: Before installing the flywheel, be sure to
wipe the crankshaft and flywheel tapers clean using a
clean, lint-free towel.
37. Place the recoil cup in position on the flywheel and
visually center; then secure the cup with three cap
screws and tighten only until snug. While holding
the cup, slide the flywheel onto the crankshaft mak-
ing sure the keyways match.
38. Apply red Loctite #271 to the threads of the flywheel
cap screw with the large flat washer; then finger-
tighten only at this time into the crankshaft.
39. Secure the recoil cup while using the spanner wrench
and tighten the three cap screws (from step 39)
evenly to 18 ft-lb.
40. Using the spanner wrench, tighten the flywheel cap
screw (from step 38) to 50 ft-lb.
CWI-070
41. Install the exhaust manifold with new gaskets and
secure with the eight nuts. Tighten the nuts in a criss-
cross pattern to 12 ft.-lb.
42. After installing the engine, bleed the oil lines using
the Oil Bleeding Procedure included with the CATT
II Tool.