Arctic Cat 2014 XF 2-STROKE, Service Manual

Page: 172 / 196

169
FS168
16. Slide the air chamber onto the shock body.
17. Add 1 cc of Fox Float Fluid into the chamber.
FS170
18. Thread the air chamber into the end cap until hand-
tight.

NOTE: Prior to installing the air chamber, make sure
the end cap O-ring is properly positioned in the
chamber.
19. Invert the shock and secure by the end cap to assure
the air chamber is tight.
FS172
20. Using a Shock Absorber Air Pump as an initial
setting, inflate the air chamber to 75 psi for the F
Sno Pro and XF Sno Pro models or 90 psi for the
M Sno Pro models and HCR models.

NOTE: The rear arm shock should be inflated to
145-150 psi on the M Sno Pro or 140 psi on the XF
Sno Pro.
FS173
21. Install the valve cap.
Servicing Fox Float X
EVOL Front Shock
Absorbers
Disassembling Shock Absorber
1. Rotate both adjuster screws counterclockwise to
the full-open position.
2. Securely clamp the EVOL chamber eyelet (bot-
tom) of the shock in a soft-jawed vise; then
remove the green valve caps and set them aside.
A
! WARNING
Do not exceed 150 psi in the shock.
! WARNING
Before starting, read through all of these instructions
first to become familiar with the procedure. Make
sure the work area is clean and all of the necessary
tools are available. These shocks contain high pres-
sure nitrogen gas. Always use proper safety equip-
ment such as latex gloves and safety glasses when
working on shock absorbers.