132
12. Install the existing flat washers between the ring nut
and the adaptor sleeve groove; then install the exist-
ing retaining ring.
XM101
NOTE: The correct combination of washers need
to stack up to take up the space in between the
adapter sleeve and the retaining ring, yet small
enough for the retaining ring to secure properly
and the washers to rotate freely.
13. Secure the lower/upper sprocket with the chain to the
driveshaft with the retaining ring and the upper
sprocket to the driven shaft with a spring washer and
cap screw (coated with blue Loctite #243). Tighten
to 25 ft-lb.
NOTE: Make sure washer is cupped toward the
sprocket.
XM201
XM200
14. Install the ratchet block; then set the tensioner in the
fifth notch in the block as it is self tightening.
XM202
15. Install the chain case cover/oil tank assembly and
secure with the existing screws (threads coated with
blue Loctite #243). Tighten in a crisscross pattern to
12 ft-lb. Fill the chain case with 15 oz. of Arctic Cat
Chain Lube.
16. Connect the speed sensor connector.
17. Install the right-side footrest support and secure to
the belly pan using the existing screws.
18. Install the resonator.
19. Secure the lower console to the skid panels; then
install the hood and both access panels.
Drive Sprockets
REMOVING
NOTE: The drive sprockets must be removed from
the brake side.
ZJ216A
1. For installing purposes, scribe a line on the drive-
shaft (A) next to the drive sprocket for proper align-
ment; then scribe a line on the driveshaft directly in
line with the timing arrows (B) on the drive sprock-
ets for proper sprocket timing.
Summary of Contents for 2014 XF 2-STROKE
