Arctic Cat 2014 XF 2-STROKE, Service Manual

Page: 48 / 196

45
Engine Servicing - 6000
This engine sub-section has been organized to show a
progression for servicing of the Arctic Cat 6000 engine.
For consistency purposes, this sub-section shows a com-
plete and thorough progression; however, for efficiency it
may be preferable to disassemble only those components
needing to be addressed. Also, some components may
vary from model to model. The technician should use
discretion and sound judgment.
SPECIAL TOOLS
A number of special tools must be available to the technician
when performing service procedures in this engine section.

NOTE: Special tools are available from the Arctic
Cat Service Parts Department.
Disassembling

NOTE: When disassembling top-side components,
mark MAG-side and PTO-side components for assem-
bling purposes.
1. Using the Flywheel Spanner Wrench to secure the
flywheel, remove the flywheel cap screw and
washer; then remove the cap screws securing the
recoil cup.
CWI-070
2. Install the Flywheel Puller Insert onto the end of the
crankshaft.
CWI-072
3. Using Flywheel Puller or suitable substitute, remove
the flywheel from the crankshaft by tightening the
puller bolt using an pneumatic gun. Account for the
key.

NOTE: To ensure the cleanliness of the flywheel
magnets, place the flywheel (with the magnets facing
upward) on a clean bench.
4. Remove the cap screw securing the ground wire to
the crankcase.
5. Remove the screw (A) securing the stator lead wire
plate to the crankcase; then remove the screws (B)
securing the timing sensors and bracket, remove the
sensors, and account for the harness grommets.
CWI-074A
6. Remove the screws securing the stator to the stator
plate. Route the stator lead wire out of the crankcase;
then remove the stator assembly.
7. Remove the screws securing the stator plate to the
engine; then remove the plate.
Description p/n
Ball Hone
0644-294
Flywheel Spanner Wrench
0144-007
Flywheel Puller
0744-040
Flywheel Puller Insert
0644-568
Extractor Nut (Medium)
0643-074
Oil Seal Protector Tool
0644-219
Piston Pin Puller
0644-328
Surface Plate
0644-016
Water Pump Bearing and Seal Tool Kit
0644-557
V Blocks
0644-535
Vacuum Test Pump
0644-131
CAUTION
To prevent damage to the crankshaft, do not thread
puller bolts more than 1/2 in. into the flywheel. Damage
to the stator may result.