Arctic Cat 2014 XF 2-STROKE, Service Manual

Page: 78 / 196

75
42. Secure the lower ignition timing sensor with two cap
screws (A) (coated with blue Loctite #243). Tighten
to 48 in.-lb; then install the grommet. With the stator
harness properly positioned, install the plate and cap
screw (B) (coated with blue Loctite #243). Tighten to
48 in.-lb.
CM177A
43. Install the key in the crankshaft.
44. Place the starter clutch in position on the flywheel;
then secure the starter clutch with three cap screws
and tighten only until snug. While holding the starter
clutch, slide the flywheel onto the crankshaft making
sure the keyways match.
CM180

NOTE: Before installing the flywheel, be sure to
wipe the crankshaft and flywheel tapers clean using a
clean, lint-free towel.
45. Apply red Loctite #271 to the threads of the flywheel
cap screw; then finger-tighten with a large flat
washer. DO NOT TIGHTEN AT THIS TIME.
FC080
46. Secure the starter clutch while using the spanner
wrench and tighten the three cap screws (from step
45) evenly to 19 ft-lb.
FC081
47. Using the spanner wrench, tighten the flywheel cap
screw (from step 45) to 50 ft-lb.
48. Install the coolant inlet hose to the cylinder head and
water pump; then tighten the hose clamps securely.
XM023

NOTE: At this time if the coolant temperature sen-
sor was removed, install the sensor (threads coated
with blue Loctite #243) and tighten to 18 ft-lb.
49. Apply a thin coat of high-temperature silicone seal-
ant to each exhaust port; then install the exhaust gas-
kets.
50. Apply a thin coat of High-Temp Sealant to the mat-
ing surfaces of the exhaust manifold; then install the
exhaust manifold and secure with the eight nuts.
Tighten the nuts using the pattern shown to 17 ft-lb.
0742-292