AMX Modero NXA-WAP200G, Instruction Manual

Page: 71 / 82

Bridge Mode Configuration Utility Pages
65
NXA-WAP200G Wireless Access Point
Basic Wireless Configuration Page (Bridge Mode)
This page can be accessed by pressing the Wireless tab from the Configuration Utility. This page’s
information is displayed in read-only format in the Access Point Information section of the Bridge
Mode Setup page. The fields in this Basic Wireless Configuration page (FIG. 51) are described in
the table below.
FIG. 50 Status page (in Bridge Mode)
Basic Wireless Configuration Page (BM) Information
Wireless Network Type: In Bridge Mode you can configure the NXA-WAP200G as follows:
• Infrastructure - Enables you to connect to any access point wirelessly.
• Ad-Hoc - Enables you to connect, on a peer-to-peer basis, with another
bridge or wireless client.
• Peer to Peer - Enables you to create a tunnel with another P2P bridge.
Peer MAC Address: The MAC Address of the peer WLAN bridge.
Wireless Network Name:
(SSID) This functions the same as in the Access Point Mode. This is the SSID for the
wireless access point, or client, which this device will connect with, must be the
same.
Note: Leave this field blank to associate with any Access Point (AP).
Desired MAC (BSSID): When there are multiple AP's in the local area, this field enables manual
selection of one specific Access Point for connectivity. The SSIDs still must
match.
Note: You can copy and past the MAC Address of the desired AP from the
Status screen.
Channel: The radio channel used by the WAP200G while in Ad-Hoc mode.
• Selections include: (see table below)
Transmission rate
(Mbits/s): Speed at which the bridge transmits data.
• Selections include: (see table below)
• Default value: Best (automatic) .