AMX Modero NXA-WAP200G, Instruction Manual

Page: 36 / 82

Wireless Device Communication Setup
30
NXA-WAP200G Wireless Access Point
duplicated within the Network Name (SSID) field on the Modero’s Secondary/Wireless
Connection page.
5.
Click on the right drop-down arrow and choose a domain from the Country/Regulatory
Domain field listing. This selection corresponds to the country where the WAP200G is
currently being used.
6.
Click on the right drop-down arrow and choose a transmission frequency from the Channel
field listing. This listing of channels is now specific to the selected Country chosen from the
above Country/Regulatory Domain field.
7.
Click the Save button to incorporate this new information.
8.
Click the Reboot button from the new Temporarily Saved page that appears.
Configuring the Modero panel for unsecured access
1. Verify the proper installation of a wireless card within your target panels.
When configuring touch panels for wireless communication, verify that no Ethernet
connector is installed within the panel before the unit is power cycled.
2. Power-up the touch panel containing the wireless card.
3. Press and hold the grey Front Setup Access button ( or the two lower buttons on both sides of
the MVP display ) for 3 seconds to open the Setup page (FIG. 25).
4. Press the Protected Setup button (located on the lower-left of the panel page) to open the
Protected Setup page and display an on-screen keypad.
5. Enter 1988 into the Keypad’s password field and press Done when finished.
If an NXA-WC802.11b PCMCIA wireless card is installed into an already powered
panel, the panel could then become "frozen" and would require power-cycling before
the new wireless card is detected. If there is both an Ethernet and wireless
connection detected by the panel, Modero will prefer the wired Ethernet mode of
communication.
FIG. 25 Setup page
Connection Status
Red Connection Status icon -
Green Connection Status icon -
indicates no connection
indicates communication
to a Master
to a Master
Clearing Password #5, from the initial Password Setup page, removes the need for
you to enter the default password before accessing the Protected Setup page.