AMX Modero NXA-WAP200G, Instruction Manual

Page: 75 / 82

Bridge Mode Configuration Utility Pages
69
NXA-WAP200G Wireless Access Point
Administration Page (Bridge Mode)
Right out of the box the NXA-WAP200G has been designed to communicate directly with Modero
panels using a Static IP Address of 192.168.1.240 (default). This allows you to configure the IP
Address used by the web server running on this bridge. When using Static information, the IP
Address information is manually entered here. When using DHCP information, these parameters
are supplied by the DHCP server on your network.
While in the Bridge Mode, this page (FIG. 54) can be accessed by pressing the Administrator tab
from the Configuration Utility. The fields are described in the table below.
FIG. 53 Advanced Wireless Configuration page (in Bridge Mode)
Administration Page (BM) Information
Device name Name the bridge uses to identify itself to external configurations and IP
Address locator programs.
Note: This is NOT the same as the SSID.
IP settings
IP Address Mode Provides the user with two options:
• Select Static to manually enter the IP settings.
• Select DHCP to get the IP settings from the DHCP server on your network.
Default IP Address IP Address of your bridge.
• The factory default is 192.168.1.240 .
Note: If you change the IP Address and forget what was used, you can press
the Reset button on the back of the physical WAP200G to restore the factory
default settings.
Default Subnet Mask This value specifies the network number portion of an IP Address.
• The factory default is 255.255.255.0 .
Default Gateway The IP Address of your networks Gateway, such as a router, in the Gateway
field. This is the IP Address of the gateway that connects to the internet.
• The factory default is 192 . 168 . 1 . 1 .