Wireless Device Communication Setup
33
NXA-WAP200G Wireless Access Point
4.
Press the
Protected Setup
button (located on the lower-left of the panel page) to open the
Protected Setup page and display an on-screen keypad.
5.
Enter
1988
into the Keypad’s password field and press
Done
when finished.
6.
Select
Protected Setup
>
Wireless Connection
(
or Secondary Connection
) to open the
Wireless Connection page. Wireless communication is set within the IP Settings section of this
page.
7.
Toggle the
DHCP/Static
field (
from the IP Settings section
) until the choice cycles to
DHCP
.
This action causes
all fields in the IP Settings section (other than Host Name) to be greyed-out.
8.
Locate the Wireless Settings section of the Wireless Connection page (FIG. 28).
9.
Touch the
Network Name (SSID)
field and from the
Service Set Identifier
keyboard, enter the
SSID name you will be using on your target Wireless Access Point (
case sensitive
).
The card should be given the SSID for the target WAP. If this field is left blank, the unit
will attempt to connect to the first available WAP.
One of the most common problems associated with connection to the WAP arises because
the SSID was not entered properly. You must maintain the same case when entering the
SSID information. ABC is not the same as Abc.
The alpha-numeric string is
AMX
by default but can be changed to any 32-character
entry.
This string must be duplicated within the Network Name (SSID) field on the WAP.
As an example, if you use TECHPUBS, you must
match the word and the case
within
both the
Network Name (SSID)
field on the touch panel’s wireless configuration page and
on the WAP’s Basic Wireless Configuration page (FIG. 30).
10.
Leave the
Authentication
field reading
Open System
.
11.
Toggle the
Encryption
field (FIG. 28) until it reads
WEP64
or
WEP128
.
The 64/128 selection
reflects the bit-level of encryption security. This WEP encryption level must match the
encryption level being used on the WAP.
Clearing Password #5, from the initial Password Setup page, removes the need for
you to enter the default password before accessing the Protected Setup page.
FIG. 28
Wireless Connection page (showing secured values)
Wireless card communication
settings with a target WAP
SSID field
Changes on this page take
effect after using the BACK
button to return to the
previous page
Summary of Contents for Modero NXA-WAP200G
