Amazone UF 1002, Operating Manual, Page: 213 / 232

Cleaning, maintenance and repairs
UF02 BAG00225.3 09.22 213
Pressure gauge test
Boom part width section chest
1. Remove one spray line from a part-width
section valve and seal it with the blind hose
(order no. 1166060).
2. Connect the pressure gauge connection to
a part width section valve with the help of
the turned socket.
3. Screw the check gauge 1/4 of an inch into
the inside thread.
4. Switch on spraying
DUS pro single nozzle control
1. Disconnect the return line (1) beside the
pressure sensor and seal it with the blind
hose (order no. 1166060).
2. Connect the pressure gauge connection
(order no. 7107000) to the spray line (2).
3. Screw the check gauge 1/4 of an inch into
the inside thread.
4. Switch on spraying.
14.15 Upper and lower link pins check
DANGER!
Risk of contusions, catching, and knocks when the implement
unexpectedly releases from the tractor!
Replace damaged top link pins and lower link pins immediately for
road traffic safety reasons.
Test criteria for top link pins and lower link pins:

Visual check for cracks

Visual check for fractures

Visual check for permanent deformations

Visual check and measurements for wear. The permissible wear
is 2 mm.

Visual check for wear on the ball sleeves

If applicable: check the fastening bolts for tightness
If a wear criterion is met, replace the top link pin or lower link pin.