Amazone UF 1002, Operating Manual, Page: 181 / 232

Cleaning, maintenance and repairs
UF02 BAG00225.3 09.22 181

Regular and proper maintenance will keep your trailed sprayer in
good condition for a long time, and will prevent early signs of
wear. Regular and proper maintenance is a requirement of our
warranty conditions.

Use only genuine AMAZONE spare parts (see "Spare and wear
parts and aids" section, page 17).

Use only genuine AMAZONE replacement hoses, and hose
clamps made of V2A for assembly.

Specialist knowledge is the requirement for carrying out testing
and maintenance operations. This specialist knowledge is not
given here in this operating manual.

Observe environmental protection measures when carrying out
cleaning and maintenance work.

Observe legal requirements when disposing of lubricants, e.g.
oils and grease. Also affected by these legal requirements are
parts that come into contact with these lubricants.

Do not exceed a greasing pressure of 400 bar when greasing
with high pressure grease guns.

The following are prohibited:

drilling the running gear.

drilling through pre-existing holes on the transport frame.

welding load-bearing components.

Protective measures are necessary, such as covering lines or
extending lines in particularly critical locations

during welding, drilling and grinding work.

when working with cut-off wheels near plastic lines and
electric wires.

Clean the field sprayer thoroughly with water before carrying out
repair work.

Carry out repair work on the field sprayer with the pump
switched off.

Thorough cleaning must be carried out before repair work can
be carried out inside the spray liquid tank. Keep out of the spray
liquid tank.

Disconnect the machine cable and power supply from the on-
board computer
when carrying out any cleaning or maintenance
work. This applies especially to welding on the machine.