Amada MF-C300A-SF, Original Instructions Manual, Page: 95 / 199

4 . Setting the Laser Light Output Schedule
95
MF-C300A-SF/C500A-SF
Chapter 2 V
arious Settings
Introduction Part
Inst
allat
ion and Preparation Part
Operating Part
Maintenance Part
Appendixes
Setting the Modulated Waveform
The method of setting the modulated waveform after displaying the MODULA-
TION screen is explained below .
⇒
When using the modulated waveform, normally set the laser output value "POW-
ER [%]" to 100%.
⇒ When the modulated laser is output, the output time may be slightly longer than
the setting.
1
Setting the Modulated Waveform
(1) Press the "MODU" button to display the MODULATION screen.
⇒ Data for a cycle of modulation wavelength is displayed as a graph on the MODU-
LATION screen. Set the ratio of the period of High in a cycle in "DUTY"; the
modulation width in "MODULATION"; and the repetition period (frequency) in
"FREQUENCY."
(2) Press the "DUTY" setting button.
Enter the ratio of the High period in a cycle (%) by using the numeric keypad and
then press the ENT key.
(3) Press the "MODULATION" setting button.
Enter the modulation width whose center is the laser output set value (SET
POWER x POWER [%]) by using the numeric keypad and then press the ENT
key.
<Note>
Set the modulation width so that the waveform after modulation becomes in the
range between the minimum of the laser output and the maximum .
High Low