Amada MF-C300A-SF, Original Instructions Manual, Page: 180 / 199

180
MF-C300A-SF/C500A-SF
Specifications
Item MF-C300A-SF MF-C500A-SF
Laser
Controller
Number of schedules 256
Schedule
setting
REPEAT mode
Laser output waveform
Laser energy for upper/lower limit judgment
Number of outputs per second
Number of repeated outputs
Modulation output waveform (when using the modulation function)
Schedule
setting
CW mode
Laser output waveform
Modulation output waveform (when using the modulation function)
Measurement function Laser energy (J), Average power (W)
Counter
Displays the total number of outputs (9 digits)
Displays the number of acceptable outputs (9 digits)
Displays the total LD ON time (7 digits)
Displays the laser output time (7 digits)
Cable length Standard 1 m
Display language Japanese and English (switchable)
Operating
Environ-
ment
Ambient temperature 10 to 35°C
Ambient humidity 20% to 85% RH (non-condesning)
Temperature during transport or
storage
-10 to 50°C
Humidity during transport or
storage
20% to 85% RH
Vibration during transport 4.9 m/s
2
(0.5 G) max.
Impact during transport 49 m/s 2 (5 G) max.
Vibration during operations 10 to 60 Hz: 0.98 m/s 2 (0.1 G) max.
Intermittent vibration during
operations
Less than 2 Hz : 4.9 m/s
2
(0.5 G) max.
Pollution degree *2 2
Altitude 2000 m or less
Others
Mass 150 kg or less
Dimensions Approx. 902 (H) × 556 (W) × 744 (D) mm
Noise level
A; Weighted
equivalent
continuous sound
pressure level
75 dB (A) max.
C; Sound
pressure level
0.3 Pa max.
Overvoltage category 2
*1 There are limitations of the total time of the laser output time in combination with
values of SET POWER and REPEAT. For details, refer to “Limitations of Sched-
ule Setting” on page 99.
*2 This index indicates the degree to which conductive pollution is generated in
the environment where the equipment is used. In pollution degree 2, only non-
conductive pollution occurs but temporary conductivity may be produced due to
condensation.
This Product uses the Source Code of T-Kernel under T-License granted by the T-Engine Forum (www.t-engine.org).