Amada MF-C300A-SF, Original Instructions Manual, Page: 135 / 199

1 . Operation Flow
135
MF-C300A-SF/C500A-SF
Chapter 5 Laser Processing by External Communication Control (RS-485 CONTROL)
Introduction Part
Operating Part
Maintenance Part
Appendixes
Installation
and
Preparation
Part
Chapter 5
●
Laser Processing by External Com-
munication Control
(RS-485 CONTROL)
1 . Operation Flow
This section explains an operation flow of a laser processing by external com -
munication control (RS-485 CONTROL) .
The following methods for laser processing operations are available: control from the
laser controller (PANEL CONTROL), control by external input/output signals from the
PLC (Programmable Logic Controller) connected to the connector (EXTERNAL CON-
TROL), and control by sending a command from the connected personal computer
(RS-485 CONTROL).
At the control by external communication (RS-485 CONTROL), the original customer-
developed program is executed on the personal computer to set laser output sched-
ules and read monitor data and various types of status.
* PLC: Programmable Logic Controller This unit exerts sequence control by executing the pro-
grammed contents of control in sequence. This is often called Sequencer (product name of Mit-
subishi Electric Corporation).
Operating Part
Press the "CONFIG" button
to display the CONFIG screen
Program execution
Control method/SCHEDULE No. settings
Laser output start/stop
Initial settings
Communication schedule setting
Equipment no. setting
Output status check
Error No. display at occurrence of trouble
Monitor value display
CONFIG
Screen
When initial settings are performed
When initial settings are already finished MAIN POWER switch ON
CONTROL keyswitch ON
LD OFF
CONTROL keyswitch OFF
MAIN POWER switch OFF
End of operations