Amada MF-C300A-SF, Original Instructions Manual, Page: 48 / 199

48
MF-C300A-SF/C500A-SF
3 . Removing the Laser Controller
3 . Removing the Laser Controller
For using the laser welder in the status where the laser controller is separated from
the main unit, remove the laser controller from the main unit.
CAUTION
Be sure to turn OFF the power supply before removing the laser controller .
Operating Procedure
(1) Hold the handle located in front of the laser controller and lift it up with holding
down its rear portion to remove it.
⇒
When putting the laser controller back in place, wind the cable. Be careful not to
stuck the cable, your fingers or hands in the housing.
Hold and lift up .
Hold down .