Amada MF-C300A-SF, Original Instructions Manual, Page: 31 / 199

2 . Name and Function of Each Section on the Top Side
31
MF-C300A-SF/C500A-SF
Introduction Part
Inst
allat
ion and Preparation Part
Operating Part
Maintenance Part
Appendixes
2 . Name and Function of Each Section on the Top Side
Top Cover Section
This section explains each section of the top cover of the main unit .
Function of Each Section on the Top Cover
(1) Head Cover This cover is opened to perform maintenance.
(2) CONTROL
Keyswitch
When the CONTROL keyswitch is turned ON with the MAIN POWER
switch ON, this keyswitch is operable. When the laser is not used, turn
OFF the CONTROL keyswitch and then pull out the key. The laser
safety supervisor should take charge of the keyswitch.
(3) Laser Controller
This controller sets welding conditions and operates the laser welder.
Setting items and set values are displayed on the touch panel type liq-
uid crystal display.
(4) EMERGENCY
STOP Button
This is an emergency stop button. With this button pressed, the laser
welder operation is stopped and the same state as that provided by
turning OFF the CONTROL keyswitch is provided. When the pressed
button is turned in the direction of RESET (clockwise), the button is re-
set to the initial state.
(5) POWER Lamp When the MAIN POWER switch is turned ON, the POWER lamp
comes on so that the operator can check that the power supply has
been turned ON.
(6) BEAM1 Lamp Always turned ON after the CONTROL keyswitch is turned ON and the
engine (oscillator) check is complete.
(7) BEAM2 Lamp Not used.
(8) READY Lamp Lights up when the LD is turned on for outputting the laser.
(9) LASER Lamp Indicates that laser is being output.
Chapter 2 Name and Functions of Each Section
(1)
(2)
(3)
(8)
(6)
(7)
(5)
(4)
(9)