Amada MF-C300A-SF, Original Instructions Manual, Page: 92 / 199

92
MF-C300A-SF/C500A-SF
4 . Setting the Laser Light Output Schedule
<Note>
If the output count set in "SHOT" is smaller than that set in "SHOT [count]", any
larger output count set in "SHOT [count]" is invalidated .
When the output count set in "SHOT" is larger than that set in "SHOT [count]", the
POWER of the final set value in "SHOT [count]" is repeated until the output count
reaches the output count set in "SHOT ."
For example, supposing that "SHOT" is set to 40, up to 40 shots are also validated
for "SHOT [count] ." (Up to 40 of POINT 03 on the above screen) When "SHOT" is
set to 300, the POWER of the final set value is repeated up to 201 to 300 shots for
"SHOT [count] ." (In this case, the 20% energy of POINT 06 is repeated up to 201 to
300 shots .)
3
Enabling the Fade Function
(1) Press the "SEAM" setting button to set it to ON.
The fade-in/out function for seam processing is enabled.
⇒ When the fade-in/out function is not used, keep the "SEAM" setting button OFF.
⇒
When the laser light output count is set to 9999 by using the "SHOT" setting but-
ton, a laser light is continuously output until the laser stop signal is input and the
fade-in/out function becomes disabled.