Alpha Group OutBack Power MATE3, Owner'S Manual

Page: 62 / 160

Basic Programming
60
900-0117-01-00 Rev A

Programming user features in the
MATE3
system display and control. (page 112) These include:

Advanced Generator Start : --------------------------------------> See page 114.
1. Setup --------------------------------------------------- > See page 115.
2. Voltage Start ----------------------------------------- >
See page 118.
3. Load Start --------------------------------------------- >
See page 119.
4. State-of-Charge Start ----------------------------- > See page 120.
5. Must Run Schedule --------------------------------- >
See page 121.
6. Quiet Time Schedule ------------------------------- > See page 122.
7. Generator Exercise Schedule -------------------- >
See page 123.
8. Set Total Generator Run Time ------------------- > See page 124.
9. Display AGS Timers --------------------------------- >
See page 125.

Data Logging --------------------------------------------------------> See page 126.

High Battery Transfer ---------------------------------------------> See page 127.

Grid Use Time --------------------------------------------------------> See page 129.

Charge Controller Float Coordination -----------------------> See page 131.

FLEXnet DC Advanced Control ----------------------------------> See page 132.

Reset to Factory Defaults -----------------------------------------> See page 133.
Accessing the Main Menu
Programming the system is done in the Main Menu screen. A password is required to access the Main
Menu screen. This password,
141 , cannot be changed.
To access the Main Menu, enter the password as follows:
1. Press the
LOCK
button.
2. While touching the control wheel, make a clockwise circle until the display shows 141 .
3. Press the center button on the control wheel to accept the password.
Figure 56 Accessing the Main Menu; Entering the Password
1
2
3
Press the
LOCK
button.
Make a clockwise circle
until the display shows
141
.
Press the center button.
If access to menus has been restricted by an installer or OEM, the Installer Password can be entered
from this menu to allow full access. Press the <
UP > soft key to enter the Installer Password. The
default Installer Password is 1732 . This password can be changed. See page 71.