Alpha Group OutBack Power MATE3, Owner'S Manual

Page: 61 / 160

900-0117-01-00 Rev A
59
Programming
Programming an OutBack system may involve the following settings.

Establishing System settings (page 61). These include:

System Information ------------------------------------------------ > See page 64.

Date & Time ---------------------------------------------------------- > See page 65.

LCD Display ----------------------------------------------------------- > See page 66.

Sound ------------------------------------------------------------------ > See page 67.

Ethernet Addresses ------------------------------------------------ > See page 68.

Ethernet Ports ------------------------------------------------------- > See page 69.

Data Stream ---------------------------------------------------------- > See page 70.

Installer Settings ---------------------------------------------------- > See page 71.

Programming Inverter parameters (page 75). These include:

Search ------------------------------------------------------------------ > See page 76.

AC Input Current Limit -------------------------------------------- > See page 77.

Grid AC Input Voltage Limits ------------------------------------ > See page 79.

Gen AC Input Voltage Limits ------------------------------------ > See page 80.

AC Output ------------------------------------------------------------- > See page 81.

Low Battery ----------------------------------------------------------- > See page 82.

Battery Charger ----------------------------------------------------- > See page 83.

Battery Equalize ---------------------------------------------------- > See page 84.

Auxiliary Output ---------------------------------------------------- > See page 85.

Inverter Stacking --------------------------------------------------- > See page 88.

Grid-Tie Sell ---------------------------------------------------------- > See page 90.

Calibrate -------------------------------------------------------------- > See page 92.

Reset to Factory Defaults ---------------------------------------- > See page 93.

Setting
Charge Controller
Limits (page 94). These include:

Charger ---------------------------------------------------------------- > See page 95.

MPPT ------------------------------------------------------------------- > See page 96.

Temperature Compensation ------------------------------------ > See page 97.

Battery Equalize ----------------------------------------------------- > See page 98.

Grid Tie Mode (not available in all inverter models) ------ > See page 99.

Auxiliary Output ---------------------------------------------------- > See page 100.

Restart Mode --------------------------------------------------------- > See page 103.

Calibrate -------------------------------------------------------------- > See page 104.

Reset to Factory Defaults ----------------------------------------- > See page 105.

Setting
Battery Monitor
parameters (page 106). These include:

Battery Setup -------------------------------------------------------- > See page 107.

Shunt Enable --------------------------------------------------------- > See page 108.

Relay Mode ----------------------------------------------------------- > See page 109.

Relay Set Points ----------------------------------------------------- > See page 109.

Reset to Factory Defaults ----------------------------------------- > See page 111.