MATE3 Settings
122
900-0117-01-00 Rev A
AGS Quiet Time Schedule
Quiet Time is a period of time when the generator should not run, due to the risk of inappropriate noise or
other reasons.
Setting start and stop times to the same time disables the
Quiet Time
function.
The
Quiet Time
settings overrides most of the “starting” set points (e.g., Voltage, Load, Must Run, Exercise
etc.), preventing the generator from starting automatically. The only exception is the
2 Minute Start
under
Voltage Start
, which is considered an “emergency” start set point and which will start the generator
regardless of
Quiet Time
settings.
To enable the MATE3 to start the generator based on the
Quiet Time Schedule
:
1.
Access the
MATE
menu as shown in Figure 113.
2.
Use the control wheel to select the
Advanced Generator Start
menu option.
Press the button in the center of the control wheel to accept the selection.
3.
Use the control wheel to highlight
Quiet Time Schedule
.
Press the button in the center of the control wheel to select the menu item.
4.
Use the control wheel to select
N
for no (disabled) or
Y
for yes (enabled).
Press the button in the center of the control wheel to select the set point.
5.
Use the control wheel to increase or decrease the
Weekday Start
time.
Press the button in the center of the control wheel to select the set point.
6.
Use the control wheel to increase or decrease the
Weekday Stop
time.
Press the button in the center of the control wheel to select the set point.
7.
Use the control wheel to increase or decrease the
Weekend Start
time.
Press the button in the center of the control wheel to select the set point.
8.
Use the control wheel to increase or decrease the
Weekend Stop
time.
Press the button in the center of the control wheel to select the set point.
9.
Press the
TOP
navigation key to return to the
Main Menu
screen.
Figure 121 MATE/AGS/Quiet Time Schedule Screen
Set points:
Enable
:
N
= No,
Y
= Yes
Weekday Start
: x0:00
Weekday
Stop
: x0:00
Weekend Start
: x0:00
Weekend
Stop
: x0:00
Summary of Contents for OutBack Power MATE3
