Inverter Settings
68
900-0117-01-00 Rev A
Ethernet Addresses
This feature is not implemented at this time.
To connect the MATE3 to a personal computer or network,
it is necessary to to enable the Dynamic Host Configuration Protocol (DHCP).
To access the
Ethernet Addresses
menu:
1.
Access the
System Settings
menu as shown in Figure 59.
2.
Use the control wheel to highlight the
Ethernet Addresses
menu.
Press the button in the center of the control wheel to accept the selection.
3.
Use the control wheel to change the value of each set point.
Press the button in the center of the control wheel to accept the selection.
The selection should automatically advance to the next set point when the button is pushed.
Repeat for each set point.
4.
After setting the parameters for each set point, press the
TOP
navigation key to return to the
System
Configuration
screen.
Figure 64
Ethernet Addresses
Set Points:
DHCP
= Enabled or Disabled
IP Address
= 192.168.000.xxx
Gateway =
255.255.255.000
DNS-1
= 192.168.000.xxx
DNS-2
= 192.168.000.xxx
Summary of Contents for OutBack Power MATE3
