MATE3 Settings
900-0117-01-00 Rev A
119
AGS Load Start
Load Start
will start a generator whenever the total system AC load wattage exceeds the
Start
set point
for the programmed amount of time (
Delay
). The generator will then be stopped when the AC load has
dropped below a
Stop
set point for a programmed amount of time (
Delay
).
When the generator is running because of
Load Start
, the inverter system will charge the batteries.
However, it is not programmed to perform a complete charge cycle. This charge might not be completed
if the generator is disconnected because of a
Stop
command.
IMPORTANT:
Large, instantaneous loads can still overload the inverter prior to the generator
starting and getting sychronizing with with the inverter.
See the inverter
Operator’s Manual
for instructions on resetting the system if an over-
current fault occurs.
To enable the AGS to start the generator based on load wattage :
1.
Access the
MATE
menu as shown in Figure 113.
2.
Use the control wheel to select the
Advanced Generator Start
menu option.
Press the button in the center of the control wheel to accept the selection.
3.
Use the control wheel to highlight
Load Start
.
Press the button in the center of the control wheel to select the menu item.
4.
Use the control wheel to select
N
for No (disabled) or
Y
for Yes (enabled).
5.
Press the
TOP
navigation key to return to the
Main Menu
screen.
Figure 118 MATE/AGS/Load Start Screen
Set Points:
Enabled
: N=No, Y=Yes
Start
: 0 to 50 kW
Delay 1 to 240 minute
Stop
: 0 to 49 kW
Delay 1 to 240 minute
Summary of Contents for OutBack Power MATE3
